Dfcvg

Classified in Language

Written at on English with a size of 2.79 KB.

 

- Configuration

1 - add three router 1841
2 - add 2960
3 - and a pc
4 - and open a router off and then go to the press you phisycal tab and add wik 2t
pork to the serial router does not bring these serial ports.
5 - the crossover cable from the router to the switch according to the port but you probably ask
is fast 0 \ 1
6 - after the switch from the PC by a parallel cable.
7 - clock time equals the serial cable dte
8 - connect to the DCE cable from router 1 to router 2 by serial 00 to serial 01
9 - now you configure the ip of the router.
10 - now that we have the ip configured in each router.
11 - to set ip commands are:


enable
config t
interface (s0 \ 0 s0 \ 1)
IP ADDRESS (AKI VA LA IP) AND AFTER THE MASK
CLOCK RATE (K ORDER DEPENDS ON WHAT THE TEACHER) 64000 ----> BE RUN IN REAL TIME
NO SHUTDOWN

This setting is applied to all the routers.

12 - IN THE ROUTER 1 Configure RIP:

ENABLE
CONFIG T
ROUTER RIP
NETWORK (IP NETWORK ALLOCATED TO THIS BOCA)
EXIT

THIS IS DONE WITH THE TWO ROUTER TO WORK WITH RIP

13 - You configure the ROUTER RIP 2 WITH PROTOCOL AND PORK IS EIGRP BORDER ROUTER.

ENABLE
CONFIG T
ROUTER EIGRP 50
NETWORK (IP NETWORK ALLOCATED TO THIS BOCA)
EXIT

ENABLE
CONFIG T
ROUTER RIP
NETWORK (IP NETWORK ALLOCATED TO THIS BOCA) INCLUDING THE IP
EXIT


14 - Redeployment MAKE ROUTE 2

ENABLE
CONFIG T
ROUTER RIP
REDISTRIBUTION EIGRP 50 metric 1
EXIT


CONFIG T
TE ROUTER RIP REDISTRIBUTE 50 EIGRP METRIC (BANDWIDTH) DELAY 255 255 MTU

15 - SET LOOPBACK

enable
config t
interface L0
IP ADDRESS (AKI VA LA IP) AND AFTER THE MASK
NO SHUTDOWN



Entradas relacionadas: