Continuous rotating servo:
This servo rotates fully forward or backwards instead of moving to a position. You can use any servo code, hardware or library to control these servos.
Position "90" (1.5ms pulse) is stop, "180" (2ms pulse) is full speed forward, "0" (1ms pulse) is full speed backwards. They may require some simple calibration, simply tell the servo to 'stop' and then gently adjust the potentiometer in the recessed hole with a small screwdriver until the servo stops moving.
Bluetooh conection procedure:
• Start the android app and select the HC6 to conect to
• If you are using the amarino library, select the data sent ( which sensor) in the android app
•Include the amarino library in your Arduino sketch and receive the data through serial as usual.